Chapter 524

Frederick, MD.
A 501(c)(3) non-profit organization. Est. 1975

Cub Work Session #135

We had a good turnout on this very cold Saturday. As a result, a lot was accomplished on engine assembly. Using the propeller hub and bolts, we mounted the engine on its stand. The crankshaft and camshaft gears were then installed. Sealant was applied to the accessory case surfaces then the gasket and accessory case were mated to the crankcase. This was followed by installation of the oil suction tube and oil tank. The engine is now ready for the installation of cylinders which will begin on Wednesday, January 10th at 9:30.
1 - 6 of 6 Photos
Rss_feed

Contact Us

Recent Videos

404 views - 0 comments
Hints for Homebilders videos at eaa.org